WhatsApp: +86 18162052962

Operation precautions and simple troubleshooting of remote control lawn mower

Operation precautions and simple troubleshooting of remote control lawn mower

By JinKuang, March 29,2021 03 Comments

Foreign remote control lawn mowers developed earlier, and currently there are many brands and extremely high prices. The remote control lawn mower of Shandong China Machinery Co., Ltd. is especially suitable for large-scale field mowing. Today, the editor will introduce you to the operation precautions and simple troubleshooting of the remote control lawn mower.

1. Operating rules: Before starting the machine, check whether the gasoline is sufficient, the oil dipstick, and the main switch of the electrical appliance. Click the start button to see if it is normal and the throttle switch is increased to the maximum. The operator keeps a safe distance from the machine before the machine runs, presses the start button, and keeps it for about 10 seconds until the engine starts. Run it for about 2 minutes under no-load condition. After confirming that the machine is normal, start work. Operators should be equipped with protective gloves, dust masks, and protective glasses. Female operators should wrap their hair to avoid accidents.

2. During the use of the remote control lawn mower, it should be guaranteed to rest for ten minutes every two hours of work, in order to minimize the load on the machine and extend the service life of the machine.

3. The remote control and the electrical parts of the lawn mower should be protected from rain or water; during use, if the engine cannot be started remotely or the remote control distance becomes shorter, the remote control battery can be replaced in time; when the lawn mower is in a long time Idle state should be checked and maintained regularly, and the battery should be charged every 1 month. (It is necessary to use a 48-volt electric vehicle lead-acid battery charger to replenish the power. The time should be controlled at about 4 hours, with full as the standard). Pay attention to moisture prevention and try your best Put it in a ventilated and dry space.

4. The front and rear protective rubber chains are damaged and should be replaced in time; the operator should be on the left or right side of the remote control lawn mower, avoiding the front and rear positions, and it is possible to prevent grass, debris, stones and other hard objects from being thrown during the operation. So as not to cause injury.

5. During the operation of the remote control lawn mower, bystanders are strictly forbidden to watch at close range, especially children should keep a safe distance away. It is forbidden to operate by minors and to operate after drinking.

6. When the lawn mower engine is difficult to start, it may be due to the following reasons: no gasoline, the spark plug wire is off, the throttle switch is not in the starting position, the oil circuit is blocked, the spark plug is damaged, the use of low-quality gasoline, and the air purifier is blocked. The corresponding solutions to the problem are: add gasoline (92* or 95*), connect the spark plug wire, adjust the throttle switch to the maximum, clean the oil circuit, replace the spark plug, select the correct brand (95* unleaded gasoline is preferred), and clean the air filter.

7. When the lawn mower trembles or vibrates violently during work, it may be caused by the following reasons: it may be caused by hitting some hard objects during the mowing process, causing the blade to bend, break, or deform, which will cause the mowing process Vibration, when the lawnmower is in use, pay attention to observe the lawn and try to avoid hard objects. If the blade is damaged, it needs to be replaced in time to avoid affecting the use effect.

The above are the operating precautions and simple troubleshooting methods of the remote control lawn mower, please keep in mind.

Leave a comment