News

Discussing how to save more fuel for small excavators has always been a problem that can not be ignored, I used to organize a lot of ways, now come to the system to look at.

On the small excavator, reduce fuel consumption has been a solid problem. Want to improve the operating efficiency of the equipment, but do not want to spend too much money on oil. Below, I have written some tips on small excavators to save oil, and I hope the following can assist you.

Specific methods:

First of all, adhere to the normal operating time temperature of the engine, especially in the freezing cold season, try to adhere to the water temperature in 75-90 ° C and according to the seasonal application of oil.

Secondly, regularly remove the cooling system scale, pipe and silencer grease and deposits.

Third, correctly adjust the brakes, often check the front and rear wheels of the tractor to maintain normal tire pressure.

Fourth, insist that the electrical system and starting organization function flawlessly. Don't set aside the small excavator engine for a long time and suspend it immediately.

Fifth, the locomotive load is appropriate. Practice has proved that the load is about 85%, the most fuel-efficient, the most economical.

Sixth, pick the real appropriate travel speed. In light load use "advanced small throttle".

Seventh, reasonable selection of small excavators and continuous operation. Correctly plan the traveling road, try to cut down the idle speed, empty load, roundabout, halfway stay, shorten the total traveling interval, cut down the inefficient energy consumption.

Eighth, timely and reasonable skill protection, so that all components and organizations adhere to the outstanding skill condition.

Ninth, clean oil, measurement and refueling. If the oil is not pre-deposited and filtered before use, the impurities in the oil will lead to the damage of the plunger and needle valve, resulting in a decrease in locomotive power and increase in fuel consumption. Therefore, the general oil should be deposited more than 48 hours before use.

Tenth, avoid oil leakage. Because of the long-term use of small excavators, touching parts touch bad, improper installation, pad damage, screws loose, pipe deformation or cracking, seal aging will lead to oil leakage. Therefore, it is necessary to adopt appropriate countermeasures to suspend fuel economy in time.

These are the ways to save fuel for each of the small excavators. When operating a roller, it can save fuel based on the above methods. Likewise, if you have any good ideas, you can also consult us.